User's Manual
Table Of Contents
- Unpacking And Installing The Printer
- Controls And Indicators
- Loading Media And Ribbon
- Printing Adjustments
- Calibrating The Printer
- Changing The Active IGP Emulation
- Configuring The Printer
- QUICK SETUP Menu
- Saving The Configuration
- Auto Save Configuration
- Selecting The Power-Up Configuration
- Loading A Saved Configuration
- Printing A Configuration
- Run A Barcode Demo Test
- Cleaning
- Repacking The Printer
- Contact Information
- For More Information
Printing Adjustments
28
Positioning The Media Sensors
Your printer is equipped with upper and lower media sensors that
detect the top-of-form position on media with label length indicators
(black marks, gaps, notches, or holes). The media sensors also
detect Paper Out conditions.
Use the handles on the lower media sensor to horizontally position
it so that the left edge of the sensor’s visible red LED is aligned
under the left edge of the adhesive label of the installed media.
The upper media sensor, located in the slot under the printhead
cover (see figure on page 27), should be located directly over the
lower media sensor.
Lower
Media Sensor
Handle (2)
Lower
Media Sensor
(left edge)
Adhesive Label
(left edge)