User's Manual
Table Of Contents
- Unpacking And Installing The Printer
- Controls And Indicators
- Loading Media And Ribbon
- Printing Adjustments
- Calibrating The Printer
- Changing The Active IGP Emulation
- Configuring The Printer
- QUICK SETUP Menu
- Saving The Configuration
- Auto Save Configuration
- Selecting The Power-Up Configuration
- Loading A Saved Configuration
- Printing A Configuration
- Run A Barcode Demo Test
- Cleaning
- Repacking The Printer
- Contact Information
- For More Information
QUICK SETUP Menu
38
QUICK SETUP Menu
(cont. on next page)
QUICK SETUP
Print Intensity
Transfer* Direct
Print Mode
2
Paper Feed Shift
Label Width
Label Length
Orientation
4.1, 6.6, or 8.5 inches*
3, 5
Portrait* Landscape Inv. Portrait Inv. Landscape
–3* –15 to 15
00.1 to 8.5 inches
5
0.00 inches*
3
4 or 6 inches*
3, 5
00.1 to 99.0 inches
6
–0.50 to
X
inches
4
Run Calibrate
Auto Calibrate
Ver Image Shift
Hor Image Shift
0.00 inches*
3
–1.00 to 1.00 inches 0.00 inches*
3
–1.00 to
X
inches
4
Tear-Off Strip* Tear-Off Peel-Off Cut
Media Handling
Continuous
Gap/Mark Sensor
Disable* Mark Gap Advanced NotchAdvanced Gap
Notes:
* = Default
1
Maximum value depends on the width of the
printer model and printhead.
2
Does not appear for direct thermal only printers.
3
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL)
See the
User’s Manual
for information.
4
Based on the current value setting for the Label
Length menu, up to a maximum of 12.80 inches.
5
Maximum value depends on the width of the
printer model.
6
Maximum value depends on model width and size
of DRAM installed.
6 ips* 1 to 10 ips
1
Print Speed