User's Manual
Table Of Contents
- Unpacking And Installing The Printer
- Controls And Indicators
- Loading Media And Ribbon
- Printing Adjustments
- Calibrating The Printer
- Changing The Active IGP Emulation
- Configuring The Printer
- QUICK SETUP Menu
- Saving The Configuration
- Auto Save Configuration
- Selecting The Power-Up Configuration
- Loading A Saved Configuration
- Printing A Configuration
- Run A Barcode Demo Test
- Cleaning
- Repacking The Printer
- Contact Information
- For More Information
QUICK SETUP Menu
48
Validator Funct.
This menu appears only if an online data validator (validator) option
is installed.
• Enabled. The printer commands the validator to begin
scanning bar codes and to report errors. The counters
increment while the validator is enabled.
• Disabled.The printer will not command the validator to begin
scanning bar codes and no errors will be reported. The
counters will not increment while the validator is disabled.
NOTE: If you save a configuration with the validator enabled,
power down and power up, and the validator is not
connected or not functioning, the error message “Validator
not communicating” displays briefly. The Validator menu
will not display.
If the validator is installed, the default is Enable.
Active IGP Emul
This function allows you to activate any resident IGP emulation
listed in the menu. The default is IGP/PGL.
There are two methods for selecting the desired emulation: directly
from the printer menu or by sending a host command which will
switch the emulation automatically (see the appropriate
Programmer’s Reference Manual
for details).
Save Config.
Allows you to save up to eight unique configurations to meet
different print job requirements. This eliminates the need to change
the parameter settings for each new job. The configurations are
stored in memory and will not be lost if you turn off the printer.
The default is 1.