User's Manual
Table Of Contents
- Unpacking And Installing The Printer
- Controls And Indicators
- Loading Media And Ribbon
- Printing Adjustments
- Calibrating The Printer
- Changing The Active IGP Emulation
- Configuring The Printer
- QUICK SETUP Menu
- Saving The Configuration
- Selecting The Power-Up Configuration
- Loading A Saved Configuration
- Run A Barcode Demo Test
- Cleaning
- Repacking The Printer
- For More Information
Loading Media And Ribbon
22
7. Verify that the left edge of the media is against the fixed guide
on the bottom of the media damper.
8. Push the media width guide in until it is flush with the outer
edge of the media.
9. Check the horizontal position of the lower media sensor
(located under the media guard) and the upper media sensor
(shown on page 27). (See “Positioning The Media Sensors” on
page 28.)
Media
Guard
Lower
Media Sensor
Fixed
Guide
Media
Damper
Media Width
Guide