User's Manual
Table Of Contents
- Unpacking And Installing The Printer
- Controls And Indicators
- Loading Media And Ribbon
- Printing Adjustments
- Calibrating The Printer
- Changing The Active IGP Emulation
- Configuring The Printer
- QUICK SETUP Menu
- Saving The Configuration
- Selecting The Power-Up Configuration
- Loading A Saved Configuration
- Run A Barcode Demo Test
- Cleaning
- Repacking The Printer
- For More Information
Calibrating The Printer
34
To avoid this problem, increase the Threshold Range value to 60%
or 70% in the CALIBRATE CTRL menu (the default is 50%), then
run an Auto Calibrate again (page 30).
NOTE: Any changes to Threshold Range will not take effect until
you run an Auto Calibrate again.
This will raise the Gap/Mark threshold high enough so that the
printer will not falsely use the antenna as the gap (top-of-form).
255
191
127
063
000
Paper Out(110)
Gap/Mark(072)
Detected Amplitude
of the Antenna
Detected Amplitude
of the Gap