User's Manual
Table Of Contents
- Unpacking And Installing The Printer
- Controls And Indicators
- Loading Media And Ribbon
- Printing Adjustments
- Calibrating The Printer
- Changing The Active IGP Emulation
- Configuring The Printer
- QUICK SETUP Menu
- Saving The Configuration
- Selecting The Power-Up Configuration
- Loading A Saved Configuration
- Run A Barcode Demo Test
- Cleaning
- Repacking The Printer
- For More Information
Making A Media Profile Printout
35
Advanced Gap Sensing
This figure shows a Media Profile printout of a smart label where
Gap/Mark Sensor is set to Advanced Gap in the CALIBRATE CTRL
menu.
In this example, the gap threshold value the printer selected
(represented by the Gap/Mark dotted line) is too close to the
amplitude of the antenna pulse. If there is an increase in noise or
the opacity of the liner or ribbon, the printer may falsely use the
antenna or noise as the gap (top-of-form).
255
191
127
063
000
Paper Out(075)
Gap/Mark(030)
Detected Amplitude
of the Antenna
Detected Amplitude
of the Gap