User's Manual
Table Of Contents
- Unpacking And Installing The Printer
- Controls And Indicators
- Loading Media And Ribbon
- Printing Adjustments
- Calibrating The Printer
- Changing The Active IGP Emulation
- Configuring The Printer
- QUICK SETUP Menu
- Saving The Configuration
- Selecting The Power-Up Configuration
- Loading A Saved Configuration
- Run A Barcode Demo Test
- Cleaning
- Repacking The Printer
- For More Information
Cleaning The Printhead, Platen Roller, And Media Sensors
55
1. Rotate the deck lock lever clockwise to open the pivoting deck
and remove any media and ribbon (if loaded) to gain access to
the printhead assembly heating element area.
2. Gently rub the felt tip of the cleaning pen or a cotton swab with
isopropyl alcohol across the printhead heating elements (light
brown area).
3. Allow the printhead to dry for one minute before reloading the
media and ribbon.
4. Clean the platen roller.
5. Clean the upper and lower media sensors.
A
Upper
Media
Sensor
Printhead
Heating
Elements
From page 54.