User's Manual

Threading The Label Roll

Figure 12. Threading Media Through the Printhead Assembly

12. Slide the media width guide close to the outside end of the media

damper.

13. Thread the leader under the media damper and then between the platen

(rubber drive roller) and the printhead.

14. Verify that the inside edge of the leader is against the fixed guide on the

bottom of the media damper.

15. Push the media width guide in until it is flush with the outer edge of the

media.

NOTE: Do not wrinkle the leader by pushing the media width guide too close

to the SLPA panel.

16. Check the horizontal position of the lower media sensor (located under

the media guard). See “Positioning The Media Sensors” on page 56.

Media Guard

Media Width

Guide

Media Damper

Fixed Guide

Lower Media

Sensor

Media Sensor

Handle

Leader