User's Manual

Removing Label Backing

If the media rewind spool needs to be unloaded during operation, proceed as

follows:

1. Press the Pause key to take the SLPA offline.

2. Tear the label backing near the media rewind hub, then reach around the

rewound backing, placing your fingers behind the hub of the media rewind

spool.

3. Pull the rewind spool away from the centerwall plate until the rewind

release bars collapse toward the center of the hub, then pull off the used

label backing. The rewind hub will snap back into position near the

centerwall once the used label backing is removed.

4. Feed a few blank labels by inserting the new edge of the label backing

into the slit on the rewind spool and manually rotate the spool at least one

turn counterclockwise.

5. Press the Pause key to place the SLPA online.

SLPA System Configuration Parameters

The following is a list of the four system configuration parameters required for

the operation of the SLPA as an RFID label printer/applicator. They are Media

Handling, RFID Reader, GPIO Port, and GPIO Table.

NOTE: You may need to set or configure other parameters for proper SLPA

operation.

Media Handling

This item selects the method of media handling.

1. Press the Menu key to take the SLPA offline and into Menu mode.

2. Press the Menu key to scroll through the Main menu until QUICK SETUP

displays.

3. Press either the ↑ or ↓ key to scroll through the QUICK SETUP submenu

until Media Handling displays in the first line of the LCD.

4. Press the + or – key to scroll through the parameters until Tear Off

displays on the second line of the LCD.

5. Press the Enter key to select Tear Off.