User's Manual

QUICK SETUP Menu Items
37
Saving The Configuration
After customizing your settings, save them as a configuration:
1. Press the key to enter the QUICK SETUP menu.
2. Press ↑ or ↓
until Save Config. / 1* displays.
3. If necessary, press + or – until the desired configuration displays.
4. Press
↵. Saving Configuration displays briefly.
NOTE: You can specify a 15-character name for your configuration. See
“Name Config (1-8)” in the
User’s Manual .
5. If necessary, set your newly saved configuration as the Power-Up
configuration. See “Selecting The Power-Up Configuration” below.
Selecting The Power-Up Configuration
To have a saved configuration automatically loaded when you power up the
printer, set the saved configuration as the Power-Up configuration:
1. Press the key to enter the QUICK SETUP menu.
2. Press ↑ or ↓
until Power-Up Config. / Factory* displays.
3. Press + or –
until the desired configuration displays.
4. Press
↵. An asterisk (*) displays next to the selected configuration.
Loading A Saved Configuration
To use a different configuration, load a saved configuration:
1. Press the PAUSE key until OFFLINE displays.
2. Press the JOB SELECT key until the desired configuration displays.
3. Press
↵. Loading Saved / Configuration displays.
WARNING Prior to any maintenance procedures, be sure to power off the SLPA
and disconnect the power cord and air supply hoses unless otherwise
indicated.
WARNING Maintenance operation should only be performed by a trained and
qualified technician.
.
.
.
.
.
.