User's Manual

88
Chapter 3 QUICK SETUP Menu
QUICK SETUP Menu
QUICK SETUP
Notes:
* = Default
1
Maximum value depends on the width of the printer
model and printhead.
2
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL).
(Refer to the
T5000r User’s Manual .)
3
Based on the current value setting for Label Length,
up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the printer
model.
5
Maximum value depends on model width and size of
DRAM installed.
6
Required for SLPA operation.
Print Intensity
6 ips* 2 to 10 ips
1
Print Speed
Print Mode
Paper Feed Shift
Label Width
Label Length
Orientation
Transfer* Direct
4.1
Portrait* Landscape Inv. Portrait Inv. Landscape
–3* –15 to 15
00.1 to 4.1 inches
4
0.00 inches*
2
4 or 6 inches*
2, 4
00.1 to 99.0 inches
5
–0.50 to X inches
3
Run Calibrate
Auto Calibrate
1* 1 to 8
Factory* 1 to 8
Save Config.
Power-Up Config.
Ver Image Shift
Hor Image Shift
0.00 inches*
2
–1.00 to 1.00 inches 0.00 inches*
2
–1.00 to X inches
3
Tear-Off Strip* Tear-Off
6
Peel-Off Cut
Media Handling
Continuous
Gap/Mark Sensor
Disable* Mark Gap Advanced NotchAdvanced Gap
(cont. on next page)
Active IGP Emul
IGP/PGL* PPI/IGL PPI/TGL PPI/IGL IGP/VGLPPI/STGL