User's Manual

List Of Messages
211
BUFFER OVERFLOW Yes Host sent data after the
printer buffer was full (serial
interface).
1. Make a configuration printout.
2. Verify that the printer matches the
host serial interface configuration
settings for Data Protocol, Baud
Rate, Data Bits, Stop Bits, Parity,
Data Terminal Ready, and Request
to Send.
3. Set printer serial interface
parameters to match those of the
host.
BUFFER OVERRUN Yes Receive overrun (serial
interface).
1. Make a configuration printout.
2. Verify that the printer matches the
host serial interface configuration
settings for Data Protocol, Baud
Rate, Data Bits, Stop Bits, Parity,
Data Terminal Ready, and Request
to Send.
3. Set the printer serial interface
parameter to match those of the
host.
CALIBRATION FAIL
See Manual
Yes Calibration values derived
from Manual Calibrate were
not acceptable.
Run Manual Calibrate again.
CANNOT CALIBRATE
Disable Peel-Off
Yes Run Calibrate was attempted
with Peel-Off Media Handling
selected.
NOTE: You can perform
Auto Calibrate in Peel-Off
mode if Cal in Peel Mode =
Enable. Be prepared to catch
labels during Auto Calibrate.
1. Select another Media Handling
option in the QUICK SETUP or
MEDIA CONTROL menu.
2. Enable Cal in Peel Mode in the
CALIBRATE CTRL menu.
NOTE: Admin User must = Enable.
CLEARING PROGRAM
FROM FLASH
Yes Emulation software
successfully loaded into
printer RAM and the
checksum matched. The old
program is now being
deleted from flash memory.
No action required.
CONTRAST TOO LOW
Check media
Yes Data validation error:
symbol contrast.
1. Adjust heat or change media.
2. Disable symbol contrast error
reports.
Table 11. LCD Message Troubleshooting (continued)
Displayed Message
Can User
Correct?
Explanation Solution