User's Manual

256

Appendix B Mounting Accessories

Mounting Accessories

U-Arm And Accessories

Figure 35. U-Arm and Offset Arms

The SLPA is designed so that it can be mounted to a stand, or other fixturing

device, using button head socket screws and U-arm. The offset arms are

provided to adapt the SLPA for mounting to the U-arm.

NOTE: The optional mounting stand that can be purchased with the SLPA

utilizes the U-arm configuration.

1. Secure the support rod to the side plates of the SLPA using the two

washers and four socket screws provided. (If the U-arm was purchased

with your SLPA, this may already be done.)

2. Secure the U-arm to the stand, or other mounting device using the two

mounting clamps, two 3/8 inch washers, and four 3/8-16 soc

ket head cap

screws

provided.

3. Insert the support rods of the offset arms into the recessed section of the

U-arm and hold into place.

Support Rod (2)

Mounting Clamp (2)

U-Arm

3/8-16 Socket Head

Cap Screw (4)

Socket Screw (4)

3/8 in. Washer