User's Manual

Mounting Stand
257
4. Secure the SLPA into place using the 3/8-16 socket head cap screws
provided with the two U-arm clamps. Torque the bolts to 36 ft-lbs in
increments of 6 ft-lbs for each bolt.
CAUTION Use extreme caution when lowering the SLPA onto the U-arm. The SLPA
is a heavy unit and may be difficult to lift by one individual. Once the
SLPA is supported by the U-arm, it must be held in place until it is
secured with the U-arm clamps. The weight distribution of the SLPA is
not balanced, therefore, it would tend to pivot on the support rods. The
U-arm clamps will supply enough pressure to hold the SLPA into place.
Mounting Stand
An optional mounting stand can be purchased with the SLPA that utilizes a
standard U-arm configuration. Offset arms are provided with all stands, that
mount directly to the sides of the SLPA, for easy assembly to the U-arm. Once
mounted on the stand, the SLPA can be rotated and locked into various
positions for printing.
Figure 36. Mounting Stand
T Base Stand H Base Stand
24.25 in.
45.50 in.
34.25 in.
67.50 in.
20.25 in.
36.0 in.
36.0 in.
63.75 in.