User's Manual

RFID CONTROL Submenus
101
Tag Void Cnt
This menu item always displays 0 unless the RFID encoder is used with an
attached online data validator. When used with a validator, Tag Void Cnt
represents how many valid RFID tags were overstruck due to bad bar code
scanning. Refer to the
Online Data Validator User’s Manual .
Tag Read Cnt
This menu item displays the number of tags read since the last Clear Tag Stat
(below).
Clear Tag Stat
This menu item clears the Tag Write Cnt, Failed Tag Cnt, Tag Void Cnt, and
Tag Read Cnt menu items.
F/W-Version
This menu item displays on the control panel’s LCD the reader firmware
version.
Precheck Tags
NOTE: This menu item applies to Class 1 tags only.
When this menu item is set to Enable, the RFID encoder checks the tags for a
pre-programmed quality code. If the code is absent, the tag immediately fails
and the selected Error Handling mode is performed (Overstrike, None, or
Stop). The default is Disable.
Overstrike Style
This menu item selects the style of the overstrike pattern. The default is Grid.
When it is set to Grid, a grid pattern prints when it overstrikes. When it is set to
Error Type Msg, an error message prints that indicates which error occurred
(see Table 2 on page 102).
IMPORTANT If you are using a validator, set the RFID Overstrike Style different than
the validator Overstrike Style (in the VALIDATOR menu). This will help
you differentiate between an RFID error and a validator error.