User's Manual

102
Chapter 3 RFID CONTROL Menu
NOTE: The
x in the error messages represents a number code that identifies
the area in the printer software or RFID encoder where the failure
occurred.
Admin User Submenus
To see these menu items, set Admin User to Enable in the PRINTER
CONTROL menu. (Refer to the
User’s Manual .)
IMPORTANT Admin User menu items should only be used by authorized personnel.
Read Tag
IMPORTANT This menu item does not position the RFID tag over the antenna. Make
sure to position the tag over the antenna to receive an accurate reading.
This menu item reads the tag in range of the internal RFID antenna and
reports the tag data to the debug port and momentarily displays it on the
control panel’s LCD. It is primarily intended for development verification by
checking that the system is working.
Read Tag&Eject
IMPORTANT This menu item does not position the RFID tag over the antenna. Make
sure to position the tag over the antenna to receive an accurate reading.
The menu item works exactly the same as Read Tag (above), except that
after the printer reads the tag, it feeds the label to the next top-of-form.
Table 2. Printed Overstrike Error Messages
Error Message Explanation
Ta g R / W E r r
x
Check media
The printer software attempted to write to or read from the
RFID tag, but the RFID encoder indicated that the tag could
not be written to or read from.
Tag Comm Err
x
Check cable
The printer software temporarily lost communication with the
RFID encoder, or communication between the printer
software and the RFID encoder was not synchronized and
had to be forced.
Precheck Fail
x
Check media
This failure occurs only when the Precheck Tags menu item
is set to Enable. It indicates that the RFID tag was
automatically failed since it did not contain the correct
pre-programmed quality code.