User's Manual

MEDIA CONTROL Submenus
119
Print Direction and Orientation are two independent options that can be
combined to produce the following results depending on the Active IGP
Emulation:
The factory default is Head First when IGP/PGL or IGP/VGL is enabled.
The factory default is Foot First when PPI1 is enabled.
Tear-Strip Time
When Media Handling is set to Tear-Off Strip or when Media Handling is set
to Continuous and Continuous Mode is set to Tear Strip Full, Tear-Strip Time
specifies the number of seconds after the buffer is empty that the printer will
wait before it advances media to the tear bar position.
The range is .1-60.0 seconds, and the factory default is 1.0 second.
Lbl Missing Flt
Allows the Label Taken Sensor to first detect the presence of a label at the
tear bar for Peel and Tear Off Media Handling Mode only.
• Enable. The printer generates a fault condition if a missing label is
encountered.
• Disable. The printer does not generate a fault condition if a missing label
is encountered.
The default is Enable.
Table 4. Head First
Print Direction
Option
Orientation Option
Result in Active IGP Emulations
(IGP/PGL or IGP/VGL)
Head First Portrait Portrait
Head First Landscape Landscape
Head First Inv. Portrait Inv. Portrait
Head First Inv. Landscape Inv. Landscape
Table 5. Foot First
Print Direction
Option
Orientation Option
Result in Active IGP/PPI1
Emulation
Foot First Portrait Portrait
Foot First Landscape Inv. Landscape
Foot First Inv. Portrait Inv. Portrait
Foot First Inv. Landscape Landscape