User's Manual

124
Chapter 3 MEDIA CONTROL Menu
TOF Adjust Mode
• Enable. This option enables the “TOF Adjust” distance set using the TOF
Adjust menu (see TOF Adjust).
• Disable. his option disables the “TOF Adjust” distance set using the TOF
Adjust menu (see TOF Adjust).
The factory default is Disable.
TOF Adjust
This opton sets the distance from the Top Of Form (TOF) that is left blank
(unprinted) after a label has been removed in Tear-Off strip or Tear-Off mode.
Normally printing is done starting at TOF, but when this mode is enabled the
start position for printing can be adjusted from 0.00 to 0.40 inches from TOF
(in increments of 0.01 inch). This adjustment can be helpful if a die cut label
sticks to the platen by means of jagged edges created during a poor die cut
label removal using the tear bar. By controlling how much blank space there is
from TOF, you can control how much the media is called back after it is torn
off.