User's Manual

140
Chapter 3 PRINTER CONTROL Menu
5. If the new lock key combination is entered again correctly, the display will
read, “Lock key has been changed.” If it was entered incorrectly, the
display will read, “Validation failed.” Start over at step 1.
6. After entering the new lock combination successfully, press the PAUSE
key to put the printer back online.
NOTE: The new lock combination will remain even if the printer is powered
off and back on.
Ptx Setup Parse
• Enable. Will parse and execute the PTX SETUP commands.
• Ignore. Will parse the PTX SETUP commands but not act on them.
• Disable. Will not parse the PTX SETUP commands so they will print out
as text.
The factory default is Enable.
Glob Mem Adjust
This menu allows you to adjust the ratio of global memory allocated to label
size versus PGL forms, fonts, and logos. For example, when using short
labels, you can allocate more memory to forms, fonts, and logos by increasing
the Glob Mem Adjust value. The default settings and adjustment ranges
depend upon the amount of installed printer DRAM and are listed below.
NOTE: You can find the amount of installed DRAM in two ways: listed at the
top of your configuration printout next to “DRAM” or from the control
panel via the DIAGNOSTIC menu next to the DRAM Installed option.
Max Font Buffer
The maximum amount of DRAM allocated for downloading fonts (True-Type,
Scalable, or Bit Map).
The range is 100 to 800 Kbytes, and the factory default is 100 Kbytes.
DRAM Installed
8 MB 16 MB
Factory Default
0.5 MB 3 MB
Range
0 to 1 MB 0 to 9 MB