User Manual



3


Printer Setup
Installing the Belt Clip and Battery
Insert the Belt Clip first
Insert the left side to install the battery on the underside of the printer, and then push the right side
of the battery down until the clasp locks
Charging the Battery
It takes 5 hours to fully charge the battery before first time usage. The lifetime of the battery is 300
charge/discharge cycles.
After installing the battery into the printer open the interface cover and plug the Charger power
cord into the printer power jack
Plug the Charger into a compatible power outlet
Note: Switch OFF printer power prior to plugging the power cord into the printer power jack
Do not remove the battery from the printer while it is charging or you will need to re-plug the
charger into the power outlet
When the battery is charging, the color of the Power LED Indicator is solid amber.
The battery is fully charged when the Power LED Indicator turns from amber to green
Battery Safety Warning:
DO NOT throw the battery in fire. DO NOT short circuit the contacts.
DO NOT disassemble the battery. DO NOT throw the battery in municipal waste
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer. Dispose of
used batteries according to the manufacturer’s instructions