User's Manual


24
Dump Mode
Printer will enter dump mode after printing Configuration Page. In dump mode, all characters will
be printed in 2 columns as shown. The left side characters are received from your system and
right side data are the corresponding hexadecimal value of the characters. It allows users or
engineers to verify and debug the program.



ASCII Data
Hex decimal data related to left column
of ASCII data















Note:
Dump mode requires 4” paper/label width.
Exit Dump mode by turning off / on the power or by pressing the FEED key. The LCD will show
“Ready” for normal printing operation.
Printer Defaults
Printer configuration will be restored to defaults as below after initialization.
Parameter Default setting
Speed 50.8 mm/sec (2 ips)
Density 8
Media Width 4” (101.5 mm)
Media Height 4” (101.5 mm)
Sensor Type Gap sensor
Print Direction 0
Reference Point 0,0 (upper left corner)
Gap Offset 0
Post-Print Action Tear mode
Serial Port Settings 9600 bps, none parity, 8 data bits, 1 stop bit
Code Page 850
Country Code 001
Clear Flash Memory No
Note: When printer initialization is done, calibrate the gap or black mark sensor before printing or
attempting any Self tests.