User's Manual


36
Print Setup for Zpl2
Item Description Default
Darkness
Use this item to setup printing darkness. The available setting is from 0 to 30, and the
step is 1. You may need to adjust your darkness based on selected media.
16
Print Speed Use this item to setup print speed. Available setting is from 1 to 4. 2
Tear Off
This item is used to fine tune media stop location in dots.
Available value is from -120 to +120 dots.
0
Print Mode
This item is used to set the print mode. There are 2 modes as below,
Tear
Off
Print Mode Description
Tear Off
Next label top of form is aligned to the print head
burn line location
Peel Off Enable the Label Peel Off mode
Print Width This item is used to set print width in dots. Available value is from “2” to “832 dots”. 812
List Fonts
This feature is used to print current printer available fonts list to the label. The fonts
stored in the printer’s DRAM, Flash or optional memory card.
N/A
List Images
This feature is used to print current printer available images list to the label. The
images stored in the printer’s DRAM, Flash or optional memory card.
N/A
List Formats
This feature is used to print current printer available formats list to the label. The
formats stored in the printer’s DRAM, Flash or optional memory card.
N/A
List Setup This feature is used to print current printer configuration to the label. N/A
Control
Prefix
This feature is used to set control prefix character.
<~>
Format Prefix This feature is used to set format prefix character.
<^>
Delimiter
Char
This feature is used to set delimiter character.
<,>
Media Power
Up
This option is used to set the action of the media when you turn on the printer.
No
Motion
Selections Description
Feed Printer will advance one label
Calibration
Printer will calibrate the sensor levels, determine
length and feed label
Length Printer will determine length and feed label
No Motion Printer will not move media
Head Close
This option is used to set the action of the media when you close the printhead
No
Motion
Selections Description
Feed Printer will advance one label
Calibration
Printer will calibrate the sensor levels, determine
length and feed label
Length Printer will determine length and feed label
No Motion Printer will not move media
Label Top
This option is used to adjust print position vertically on the label.
The range is -120 to +120 dots.
0
Left Position
This option is used to adjust print position horizontally on the label.
The range is -9999 to +9999 dots.
0
Note: If printing from enclosed software/driver, the software/driver will send out the commands,
which will overwrite the settings set from the LCD panel