User's Reference Manual Multifunction Printer P9000 Series

Operation2-2

Yo u

can

also define and download an international language to allow any character within the

character library to be substituted for any code. Similarly, an individual character in a font, or

entire set of characters, can be created

and placed in a font. These downloading features are

discussed

in more detail in the P

rogramming chapter and the Appendix.

Power Switch

The

C power switch is located at the lower left corner of the rear panel of the printer. T

o turn

the

printer power on, set the power switch to the ON (|) position.

- WARNING -

The

power cord requires an IEC (hot) connector to mate to the receptacle on the rear

panel

of the printer

. The hot connector includes a polarizing key which prevents the

use

of cordsets that are not of the correct rating for the printer

- WARNUNG

Das Stromkabel benötigt einen IEC (spannungsführenden) Stecker, der in die

Steckdose an der hinteren Wand des Druckers passt. Der spannungsführende

Stecker kommt mit einem Nulleiter, der die Benutzung von Stromkabeln ohne die

korrekte

Nennleistung für den Dr

ucker verhindert.

The Control Panel

The

printer control panel

is illustrated in Figure 2-1. Each component of the control panel is

discussed on the following pages.

Status Lamps

The

status lamps are lit continuously when the printer is on line to the host and are off when the

printer

is off line. The lamps flash alternately if a fault condition exists in the printer.

Alphanumeric Message Display

The

message display shows printer status and fault

condition messages. During normal opera

tion,

the display indicates the on line status and the current print mode (and pitch) selection.