Specifications

MEDIA SETUP Submenus

Fault Reprint

This option determines how the printer handles data that was printing when

an error occurred.

• Disable (factory default). The printer will not reprint the label that was

printing when the error condition occurred.

• Enable. The printer reprints the label that was printing when the error

condition occurred.

NOTE: When Fault Reprint is set to Enable and a RIBBON OUT condition

occurs, some labels may not reprint. This depends on the label

length, print speed selected, and the additional time it takes to detect

this condition. Be sure to verify that all labels were reprinted after a

RIBBON OUT condition by using the Ribbon Low indicator as

described on

page 81.

Ribbon Low

When enabled, and the ribbon remaining on the supply spindle is less than

1/8 full, the Attention indicator will flash, and "Ribbon Low" displays on the last

line of the LCD. A Ribbon Low warning will not prevent printing.

The options are Disable (factory default) and Enable.

The Ribbon Low submenu is available if Admin User is set to Enable in the

PRINTER SETUP menu.

Units

This item selects either millimeters or inches as the unit of measure.

The options are In Inches (factory default) and In Millimeters.

Set Label Length

This feature selects whether the Sensed Distance value derived from an Auto

or Manual Calibrate will be used to set the Label Length value in the MEDIA

SETUP menu.

• Manual (factory default). The Sensed Distance value derived from an

Auto or Manual Calibrate will not override or change the Label Length

value.

• Automatic. When an Auto or Manual Calibrate is performed, the Sensed

Distance value derived from either calibrate will override and change the

Label Length value. If no Auto or Manual Calibrate is performed, the

current Label Length value will be used.

NOTE: When Set Label Length = Automatic and Gap/Mark Sensor = Gap,

the printer will subtract the Gap Length value (in the SENSOR

SETUP menu) from the Sensed Distance value obtained when the

Auto or Manual Calibrate was performed.

If you set the label length to Automatic, the Enable setting for Use

Label Length under the Sensor Setup menu will be ignored.