Manual

Modifying A Saved Configuration

You can change a saved configuration by rewriting over it. For example, you

can modify Config. 1, shown below. Suppose you want to keep all the settings

but you want to select the parallel Centronics interface instead of the IEEE

1284 interface.

1. Load the configuration to be changed (for example, Config. 1).

a. Press the key until the following message displays:

b. Press the ↓ key until the following message displays:

c. Press the

+ or − key to cycle through the options: Factory 1-8.

d. When the desired number displays, press the ↵ key to select it. The

following message displays:

Then, the following message displays when it is loaded:

2. Move through the menu and change all the desired values. (In this

example, press the key until PARALLEL PORT displays. Press the ↓

key until Port Type/IEEE 1284 displays. Press the - key until Centronics

displays.)

3. Press the ↵ key to select each new value. An asterisk (*) displays.

MENU MODE

CONFIG. CONTROL

Load Config.

Factory

Loading Saved

Configuration

Load Config.