Specifications

Prism Media Products Limited AD-2 Dual-rate A/D converter
Operation Manual
Issue 0.2 © Prism Media Products Limited
11 August 1998 Page 19 of 58
4.2. To reset the AD-2 to its factory default state
USE THIS WITH CARE, AS THE USER STORES WILL BE CLEARED.
Use the [99] key to enter the menu system and hold it down until Preferences is
displayed. Press [Enter], then press [99] until you see:
Reload Factory
Defaults/Stores?
Press [Enter] and at the prompt Enter to Accept press [Enter] again.
4.3. Setup Wizard
The Setup Wizard helps you create custom A-D configurations. It provides choices of
sample rate, wordlength, synchronization, maximum input level and digital interface
format.
The Setup Wizard will allocate Main Output to all output connectors.
If you require an Auxiliary output with different settings, you can use the result of the
Setup Wizard as a base and then change the Auxiliary output and Output connector
assignments using the Menu system.
To use the Setup Wizard, press the <Setup Wizard> button on the far right of the AD-2
front panel and follow the prompts in the LCD display. The first prompt will be:
* Setup Wizard *
Enter to start.
From this point forward, continue or confirm a selection using the [Enter]/Accept key or
change the selection using the [77] and [66] (Edit/Change) keys. Repeated use of either
key will cycle through the list of alternative selections.
When the desired selection is displayed, confirm it using the [Enter]/Accept key.
Continue with the process of selecting settings until you see:
You can save
this setup...