Specifications

Prism Media Products Limited AD-2 Dual-rate A/D converter
Operation Manual
Issue 0.2 © Prism Media Products Limited
11 August 1998 Page 20 of 58
Press [Enter] and you will see:
Empty stores ->
are flashing...
At this point for each empty user store, the corresponding LED
above the store button will be flashing.
If you do not wish to store your setup, simply press [Enter], ignore the prompt to
select a store and press [Enter] again. You will see:
Setup not
Saved
Then press [Enter] to finish. Alternatively..
If you wish to store your custom setup, press one of the 4 store buttons; you can
overwrite an existing store if you wish - in this case you could select one that was not
flashing. You will then see:
Setup saved as
xxxxxxxxx by Wzd
Note : The Setup Wizard creates a text description which is displayed in the bottom line of the display (xxxxxx’s
indicate where the description is displayed). This is the text description for the store. It can be changed by
editing the store description according to section 4.5.4.
Note: The LED’s continue flashing after store selection - your selection, whether an empty or used store, is
confirmed after the next step....
Press [Enter] to finish and return to the normal level display.
You may then wish to modify the setup such as to set an alternative function and output
connector for the Auxiliary output. See section 4.6.
4.4. Program level meter
The Program level meter is a peak reading meter with one sample attack time and
normal or peak hold display modes.
The exact level is displayed on the LCD display (in its normal mode of operation) for
both left and right channels.
The default mode is ‘normal’ in which transient meter deflections will be followed by a
controlled decay of the indication and where the occurrence of overloads is momentary
[“Over” indicator ON]. [Overs are stretched for a minimum period so that brief overs