Specifications

Prism Media Products Limited AD-2 Dual-rate A/D converter
Operation Manual
Issue 0.2 © Prism Media Products Limited
11 August 1998 Page 23 of 58
4.5.2. Save settings to a user store
Prior to saving the AD-2 settings to one of the user stores you will probably have
created a custom configuration by one of the following methods:
" Using the (A-D modes) Setup Wizard (without saving at that time)
" Using an existing store (Factory Preset or User) and modifying it
" Creating it from scratch using the Menu controls
Before saving your settings to a user store it is advisable to preview the store to check
that it is empty or to make sure that you will not overwrite something that you wish to
keep.
Step 1 From the normal Level: display, press either the
<A-D Modes> button or the <D-D Modes> button
to select the appropriate mode.
Step 2 If you wish to preview a Factory Preset store, press
<Factory Presets> and/or check that the
corresponding LED is lit.
Step 3 Press the selector button for the desired store i.e. one of <1> to <4>. The
corresponding LED will flash.
Step 4 Inspect the text description. If the store is empty, the display will read
Empty Store.
Step 5 Repeat steps 3 & 4 to preview other stores if desired.
You may then cancel the preview by pressing the same store button again [or by
pressing either the [88] or [99] keys].
4.5.2.1. Saving to an empty store using the default store description
Step 6 Press the [Enter] key. A default store
description will be displayed in the top line of the
display. [The description can be edited at this
point or later - see below.]
Step 7 Press the [Enter] key again to accept the
default description. Finally, you will be
prompted to confirm the save operation with:
Enter to save