Specifications

Prism Media Products Limited AD-2 Dual-rate A/D converter
Operation Manual
Issue 0.2 © Prism Media Products Limited
11 August 1998 Page 24 of 58
Step 8 Press [Enter] again to confirm. Your current settings will be stored.
Alternatively, press [88] or [99] or the button under the flashing store LED to
cancel the store operation [or double press any other store button <1> to
<4> or <Setup Wizard>.]
4.5.2.2. Saving over an existing store using the default store description
Step 6 Change the store operation from ‘Load’ to
‘Save’ by pressing the [66] key.
Step 7 Press [Enter]. A default store description will
be displayed in the top line of the display. [The
description can be edited at this point or later -
see below.]
Step 8 Press the [Enter] key again to accept the
default description. Finally, you will be prompted to confirm the save
operation with:
Enter to save
Step 9 Press [Enter] again to confirm. Your current settings will be stored.
Alternatively, press [88] or [99] or the button under the flashing store LED to
cancel the store operation [or double press any other store button <1> to
<4> or <Setup Wizard>.]
4.5.2.3. Saving a store with your own store description
If you are saving to an empty store, use the procedure of section 4.5.2 up to and
including Step 6 in section 4.5.2.1.
If you are saving to a store that has already been used, follow the procedure of section
4.5.2 up to and including Step 7 in section 4.5.2.2.