Specifications

Prism Media Products Limited AD-2 Dual-rate A/D converter
Operation Manual
Issue 0.2 © Prism Media Products Limited
11 August 1998 Page 32 of 58
“Auto” indicates the state of the auto-dither system, which can intelligently set itself on or
off according to various conditions such as an input of digital zero or input of a
wordlength less than or equal to the output wordlength. For more information see
section 7.3.2.
4.8.6. Output Assignment Indicators
These show the routing of the Main and Aux channels to the various
output connectors and give some indications about the format.
In between the XLR-1 and XLR-2 indicators and similarly between
the BNC-1 and BNC-2 indicators are yellow LEDs which indicate a
link between the two outputs.
This can have two alternative meanings:
4.8.6.1. Split96 or 2-wire mode
This LED is lit when either connector pair are configured in the Split96 or 2-wire mode
for either 88.2 or 96.0kHz sampling. For more information see section 6.3.
4.8.6.2. SDIF-2 format
This indicates that the SONY SDIF-2 format is selected. This may operate at low or
high sample rates but may only be selected on the BNC outputs. See section 6.3.