www.prismatibro.se

2:11 DELETE DOCUMENTS
This menu provides two options; delete a single document or, delete all documents.
Delete single document:
Follow section 2:8 above until DELETE DOC is displayed, press OK.
The display will read ARE YOU SURE, NO ? If ‘NO’ press OK, the display will move to
FIND OTHER DOCUMENTS. If arrow right > is pressed the display shows ARE YOU SURE,
YES ? If ‘YES’, press OK.
Display will now show DOCUMENT DELETED and return to FIND STORED DOCUMENTS.
Delete all stored documents:
To delete all documents you should follow the procedure below;
•
Start the instrument by pressing OK, accept date/time with OK.
•
Pressing the right > arrow twice the display will move to
DELETE ALL DOCUMENTS, press OK. The display will read ARE YOU SURE NO ?.
If ‘no’ press OK, otherwise press right > arrow button to menu ARE YOU SURE, YES?,
press OK to delete all documents.
The program will returns to menu NEW DOCUMENT status.
We recommend you consult the ow scheme in section 5. This will greatly assist in
understanding the sequence of events.
2:12 BATTERY CHARGE
When the power of the battery goes low, a battery indicator will indicate low battery
level in the left side of the display.
A built-in protection circuit will switch o the instrument automatically when the
voltage reach 3,2V to protect the battery from being totally discharged.
Charge the battery with the charger until the led indicator of the charger
switches from red to green light.
3. DATA TRANSFER TO PC
All data stored in the DI-5C can be transfered to a PC. The software and USB cable
included with the instrument has been developed to make the operation as simple as
possible.
It is also possible to connect the instrument directly to a PC while taking measurements
from the engine. Pressing OK while measuring values A - E will automatically transfer
the measuring data to the PC program.
NOTE! Remember to save the measurement data as a le in your PC.
See the separate “Program Manual for PC”
4. CYLINDER LINER MEASUREMENT
The DI-5C also has a preprogrammed function for storing up
to 45 cylinder liner measuring documents.
The accessory Ovality Kit, part no. 488-8100 is required for
cylinder liner measurement. This measuring equipment can
be used to accurately record ovality patterns of cylinders
ranging between 180 mm to 600 mm bore. Larger liners
may be measured with additional extension bars supplied
by Prisma Teknik.