www.prismatibro.se
9. OVALITY PAGE
The OVALITY page is intended for cylinder liner ovality measurements only.
Page F5 will display ”OVALITY DIAGRAM”. This is automatically changed by the Prisma
DI-5C when selecting ´Crankshaft measurement´ or ´Ovality measurement´ during
set-up of the Prisma DI-5C.
Each level is displayed for each position on the screen left side.
The prole displayed on the right side shows the ovality for each level.
Ensure that measurements are recorded with Level 1 at the bottom of the cylinder liner,
otherwise the readings will be reversed (upside down).
Should you wish to alter measurement angles, go to ´Preferences´ window in the menu
and select ´Options´.
Print, Load and Clear documents at will, as previously described.