Instructions / Assembly

【Instruction for Remote Controller and Switch Panel】
Flame setting
Top light setting
Timer Setting
Power ON/OFF
Heat setting
Temperature setting
Control Panel / Remote Control Operation
(Control panel POWER switch must be ON to use remote control.)
The touch display panel is shown by LED's on the front bottom right of the appliance. The LED's will
appear on the bottom of the fireplace control panel.
POWER
Turns the appliance ON/OFF.
FLAME
Controls Flame colors.
3 Settings: ( L1 yellow-L2 blue-L3 purple-cycle)
Top light
Controls Top light colors.
3 colors : ( F0 OFF-F1 yellow-F2 blue-F3 purple-cycle)
.
HEATER
Controls the Heater.
Press button to initiate the heater.
(OFF) no heater or blower.
(LO), heater blows warm air (750W)
(HI), heater blows hot air (1500W)
NOTE: Heater functions cycle from OFF-LO-HI
TIMER
Controls the Timer.
9 Settings: (1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h,9h) Press button
until reach desired setting.
TEMPERATURE
1. Press once: Control panel indicator becomes active.
2. Press again until desired setting is reached. Digital display
shows setting circles as below.
NOTE: Press the button for 15 seconds, the temperature
setting will switch from °C to °F. Same way from °F to °C.
WARNING : Do not move or remove the mesh trim panel, when the appliance is plugged in and
operating. This will cause the remote control and touch panel to no longer function.
Display Value
1
2
3
4
5
6
Temperature
°C
22
24
26
28
30
37
°F
71
75
78
82
86
99