Installation Instructions

Bottom Locking
Double Wall Slats
Decorative Privacy Fence Slats
Features and Benefits
Materials – Slats are extruded from High Density Polyethylene
(HDPE), color pigments and ultra violet (UV) inhibitors
specifically formulated to retard the harmful effects of the sun
and lengthen the life of the slat.
Durability
– Our slats are also resistant to severe weather
conditions, salt water, sand, road dirt, most acids, alcohol,
alkaline, ammonia, petroleum distillates, and common
environmental pollutants.
Maintenance – Our slats are nearly maintenance free. They may
be pressure cleaned of surface contaminants with plain water.
Wind Load Disclaimer – We will not be held responsible
for fence damage resulting from wind load conditions due to
insufficient structural support.
Designations – Meets ASTM Designation: F3000/F3000M
(except HedgeLink and Aluminum Slat)
Exact representation of colors in printing is difficult. Please
refer to actual color samples for accurate matching. Samples
available upon request.
Available Colors
(colors are approximations)
Beige Redwood Black White
Royal Blue Forest Green
Gray
Dark Brown
Sky Blue
HDPE Technical Properties
Property Values
Melt Index (.6) A low melt index indicates improved stress and crack resistance.
Density (.957) Polyethylene ranges anywhere from .914 to .960 in density.
A higher density yields maximum stiffness without becoming overly brittle.
Minimum Temp. (-76º F) Polyethylene stays flexible even at this temperature extreme.
Maximum Temp. (250º F) Polyethylene does not distort until reaching this temperature.
Tensile Strength (3,700 psi) Material will not suffer distortion at lesser loads or impacts.
Bottom Locking Double Wall Slats are an economical
and attractive way to enhance any chain link fence. The
bottom locking design makes this one of the easiest slats
to install and assures a clean level finish.
Design – Flat tubular shape with inside reinforced “legs” for extra
durability. The locking channel creates a “snap-in” locking effect
for security and deters vandalism.
Installation – Insert the locking channel horizontally through
the bottom of the fence, then simply slide the slats vertically
from the top towards the bottom channel and they will
automatically lock into place.
Standard Heights – 4 ft., 5 ft., 6 ft., 7 ft., & 8 ft.
Slat Length – 3 1/2” shorter than the overall height of the fence
Wind Load and Privacy Factor – Approximately 75% (Based on
wire/mesh used-stretch tension)
Colors – Beige, Redwood, Black, White, Royal Blue, Forest Green,
Gray, Dark Brown, Sky Blue
Slat Name
Slat Minimum Wire Coverage
Width Mesh Size Gauge Area
Bottom Lock 2” 1 3/32” 2” 9 or 11 10 linear
Commercial, Industrial & Residential Fence
Products and Accessories!