User's Manual

Privaris BPID™ LFBT Security Device, V1.4
PROBLEM
Device will not power on.
1. Open battery compartment by inserting tip of pen into the battery
release (see Figure 2).
2. Remove cover.
3. Remove battery.
4. Put the same battery back, making sure that it is secured tightly
and properly aligned. It should be touching the battery contacts
on the top and bottom of the compartment, and the positive (+)
end should be pointing toward the tip of the device.
5. Replace the battery cover by aligning it with the ridges of the
battery compartment and sliding it back into position. Make sure
that it is latched securely in place. A loud click is heard when
properly closed.
If the device still does not power on, replace the battery with a new
one (see below).
__________________________________________________________
PROBLEM
Quick flashing red light seen anytime during operation OR a quick
flashing red light and then device powers itself off.
A flashing red light is an indication of a low or critically low battery.
1. Replace battery. The battery is a standard CR2 lithium camera
battery. It can be easily replaced by inserting the tip of a pen
into the battery release (see Figure 2) and pressing down to
release the battery cover.
2. Remove the old battery and insert the new battery with the
positive (+) end pointing toward the top of the device and ensure
that it is secured tightly in the compartment. It should be
touching the battery contacts at the top and bottom of the
compartment.
3. Replace the battery cover by aligning it with the ridges of the
battery compartment and sliding it back into position. Make sure
that it is latched securely in place. A loud click is heard when
properly closed.
Replacing the battery does not require the user to be re-enrolled.
11