Model #UE42V-NI-SHB USN# 3574541 USE AND CARE GUIDE MIDDLETON 42 in CEILING FAN An electronic copy of this user manual can also be obtained online at homedepot.
Table of Contents Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Troubleshooting . . . . . . .
Warranty LIMITED WARRANTY WHAT IS COVERED The retailer warrants the fan motor to be free from defects in workmanship and material present at time of shipment from the factory for a period of lifetime after the date of purchase by the original purchaser.
Pre-Installation (continued) PACKAGE CONTENTS NOTE: Unpack your fan and check the contents.
Installation Determining Mounting Method Installing the Support Bar REMEMBER to turn off the power. Follow the steps below to hang your fan properly. WARNING: personal injury, mount to outlet box marked acceptable for fan support of 15.9 Kg (35 lbs.) or less and use mounting screws provided with the outlet box. Secure the supporting bar to the ceiling outlet box as shown in Figure 4 by using two screws and washers (not provided). Make sure the supporting bar is level.
Installation (continued) Making the Electrical Connections Ƒ If you choose to install another light kit, it must be a UL-listed light kit accessory marked suitable for use with this fan. Follow the instructions packed with the light kit. WARNING: To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. If you are not sure the electrical box and fan are grounded, contact a licensed electrician for advice. They must be grounded for safe operation.
Installation (continued) 4 Finishing the Installation 1 Secure the fan assembly onto the supporting bar (A) using the preassembled screws (1) and washers (2) (Figure 10). A 2 Fix the motor housing (B) onto the supporting bar (A) by tightening the four screws (3) preassembled to the motor housing (B) (Figure 11). Attach the fan pull chain pendant to the pull chain on the switch assembly.
Installation (continued) Attaching the Fan Blades NOTE: Your fan blades are reversible. Select the blade side finish that best accentuates your decor. Failure to follow above procedure could result in fan wobble. Ƒ Position the blade holder (D) under the motor such that the alignment post on the blade holder fits into the slot (3) in the motor (Figure 13). Ƒ Tighten the pre-installed blade holder screws (2). Ƒ Repeat these steps to install the remaining blade assemblies.
Installation (continued) Balancing the Blades Installing the Light Kit All blades are grouped by weight. Because materials vary in density, the fan may wobble even though the blades are weight matched. WARNING: To reduce the risk of electric shock, disconnect the electrical supply circuit to the fan before installing light kit. The following procedure should correct most fan wobble. Check for wobble after each step. CAUTION: Do not use pliers or screwdrivers to tighten the thumb screws.
Operation Operating NOTE: Wait for the fan to stop before changing the setting on the slide switch. The pull chain controls the fan speed as follows: 1 pull – High, 2 pulls – Medium, 3 pulls – Low, and 4 pulls – Off. The slide switch controls direction: forward (switch down) or reverse (switch up).* Speed settings for warm or cool weather depend on factors like room size, ceiling height, number of fans, and so on. Warm Weather – (Forward) A effect as shown in Figure 17.
Care and Cleaning WARNING: Make sure the power is off at the electrical panel box before you attempt any repairs. Refer to the section Making Electrical Connections Section. Here are some suggestions to help you maintain your fan. Ƒ Because of the fan’s natural movement, some connections may become loose. Check the support connections, brackets, and blade attachments twice a year. Make sure they are secure. (It is not necessary to remove the fan from the ceiling.
An electronic copy of this user manual can also be obtained online at homedepot.com Retain this manual for future use.
