JRP 40600 GEBRAUCHSANWEISUNG OPERATING INSTRUCTION D t 2222659-16
t Safety Instructions Please read these operating instructions carefully before installing the appliance. These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. If you are unsure about the meaning of these warnings contact the Customer Care Department. Domestic Use ¥ The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only.
Instructions for the use of the instructions booklet Notes which are important for your safety or for the proper functioning of the appliance Supplementary information regarding operation and practical applications of the appliance. Tips and notes concerning economical and environmentally sound use of the appliance Disposal Appliance Packaging Information ¥ The materials used on this appliance marked with the symbol are recyclable.
Hints Saving Energy D338 ¥ For better use of space, the front half-shelves can lie over the rear ones. The glass shelf above the vegetable drawers and the bottle shelf should always remain in position, to ensure correct air circulation. Door shelves ¥ To permit storage of food packages of various sizes, the central door shelf can be adjusted in height. ¥ Gradually pull the shelf in the direction of the arrows until it comes free, then CP1SIG reposition as required.
Maintenance Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Defrosting ¥ Defrosting the refrigerator compartment is automatic. The defrost water drains out through a trough into a container at the back of the appliance, above the motor compressor, where it evaporates.
Something not Working Problems may be due to causes which can easily be solved before calling the Technical Service. Please follow these instructions: SYMPTOM SOLUTION Door does not close Weight surpasses the storage limit of the door shelf so spread weight more evenly or take some products out. The appliance is not properly installed. Please look in the ÒBuilding-inÓ section. It is too warm inside the refrigerator Set a lower temperature.
Door reversal 1. Pull off the ventilation grille (D), which is a clip-on fit. Remove the bottom hinge (E) by unscrewing its two fixing screws. 2. Remove the plugs (G) and fit them on the opposite side. 3. Remove the door (4). 4. Unscrew pin (2) and screw it onto the opposite side. 5. Refit the door. 6. Refit the bottom hinge on the opposite side using the two screws previously removed. 7. Slide the hole cover (F) off the ventilation grille (D) and fit it on the opposite side. 8.
The following table shows which ambient temperature is correct for each climate classification: Climate classification for an ambient temperature of SN +10 to +32¡C N +16 to +32¡C ST +18 to +38¡C T +18 to +43¡C Panelling the door 1. Take off the door frame section opposite to the door handle. Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage.
Building in the appliance under a worktop Dimensions of the recess The dimensions of the recessed installation area must correspond with those indicated in the figure. ¥ Holes (H) in the top hinges are used for fixing the appliance to the worktop. Installation kit ¥ If the recess height is 870 mm, the appropriate fitting kit must be used. ¥ The kit contains the following parts: - 1 ventilation grille; - 2 adjustable feet; - 2 non-adjustable feet; - 1 set of screws - 1 instructions.
