Installation Instruction

READ AND SAVE
SAFETY PROCEDURES FOR INSTALLING
YOUR NEW PRIZER HOOD (continued)
UPON RECEIVING YOUR HOOD...
3
CAUTION - TO REDUCE THE
RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PEOPLE,
OBSERVE THE FOLLOWING:
CAUTION - FOR GENERAL
VENTILATION USE ONLY. DO
NOT USE TO EXHAUST
HAZARDOUS OR EXPLOSIVE
MATERIALS OR VAPORS.
A.
B.
Installation work and electrical
wiring must be done by a
qualied installer in accordance
with all applicable codes and
standards, including re rated
construction.
Sucient air is needed for proper
combustion and gas exhaustion
through the ue (duct cover) of
fuel burning cooktop to prevent
backdrafting. Follow the
equipment manufacturer’s
e high degree of craftsmanship in the construction
and nish of your hood requires careful handling to
ensure proper installation.
Do not remove your hood from its carton until you are
ready to hang it.
Do not store your hood anywhere other than within the
carton. If it is necessary to remove your hood from the
carton, place it on a blanket or padded area that will
protect your hood from scratches or indentations.
Do not lift the hood by its utensil rail. Place your ngers
under the lower reveal of the hood. Grasp rmly and
lift.
•
•
•
•
Wearing cotton gloves are preferred. ey will protect
the surface from ne scratches and eliminate
ngerprints.
Remove all rings, watches, belt buckles, and jackets
(snaps-zippers) to prevent scratches on the hood.
If applicable, do not remove the cotton annel from your
hood until the installation process is complete. It will be
necessary to remove only a small portion on the
back-side for a wall mounted hood in order to position in
place.
Located within the hood cavity (behind the bae lters)
are component parts and halogen bulbs.
•
•
•
•
C.
D.
E.
guidelines and safety standards
such as those published by the
National Fire Protection
Association (NFPA), and the
American Society for Heating,
Refrigeration and Air
Conditioning Engineers
(ASHRAE), and the local code
authorities.
When cutting/drilling into a wall
or ceiling, avoid damage to
electrical wiring and other
hidden utilities.
In-hood or in-line fans must be
vented to the outdoors.
If a ventilation unit is to be
installed over a tub or shower, it
must be marked as appropriate
for the application and be
connected to a GFCI (Ground
Fault Circuit Interrupter) -
protected branch circuit.
F.
G.
H.
I.
NEVER place a control switch
where it can be reached from a
tub or shower.
CAUTION - TO REDUCE THE
RISK OF FIRE WITHIN WALLS
OR ROOFS, USE ONLY METAL
DUCTWORK.
Install this hood in accordance
with all requirements specied by
the manufacturer of your
cooktop/range.
Install this hood using required
clearance from cooking surface to
combustible material specied in
cooktop installation instructions.