Installation instructions

e Chimney Style Hood can adapt to a rear discharge application but with the following limitations:
A rear discharge application only works when using a 24" tall duct cover or taller. e 12" and 18” tall duct covers do not allow
enough room to house the transition (with damper) and an elbow. e rear discharge cannot be made within the hood itself. It can
only be made in the duct cover.
Remove the screws from the back of the duct cover, followed by removing the rear panel of the duct cover. is will allow the
ducting to exit from the rear of the duct cover. (see Figure 11.)
24" Duct Cover required
to t Transition and
Elbow.
Supply
Ductwork
Range
Remove
Rear Panel
on
Duct Cover
9
INSTALLING A CHIMNEY STYLE HOOD
WITH A REAR DISCHARGE THROUGH DUCT COVER
Figure 11.