Installation instructions
In certain situations the installer may opt for a dierent
installation sequence. e alternate sequence is listed below.
opening in top of structure, if available. (see Figure 7. - Page 6)
Install Transition to ductwork, ensuring transition bottom
Attach the Hood to the Duct Cover. Fasten the Hood to
connection of the transition to ductwork). (See Figure 8.)
transition to ductwork. If mechanical fasteners are used, apply
Duct Cover to locate studs). (See Figure 9.)
installation instructions, on page 6
Supply Ductwork
Range
Alternate
Installation
Attach Fan to
Rectangular Plate Using
Supplied 10-24 Nuts.
Plug “Y” Pigtail into
Each Fan and
Single End into Hood.
Supply Ductwork
Screw Transition to
Rectangular Plate.
Range
Alternate
Installation
Bolt Hood
to Duct Cover.
Drill & Screw
Hood to Structure.
Supply Ductwork
Range
Alternate
Installation
Transition; Position Exhaust Ductwork
so Bottom of Transition is Flush & Centered
with Bottom of Duct Cover.
8
Figure 8.
Figure 9. Figure 10.
AN ALTERNATE INSTALLATION FOR A CHIMNEY STYLE HOOD