Installation instructions

Duct Tape
Shipping Screws
Removable Back Panel
10" Transition
TRANSITION INSTALLATION AND REMOVAL
Shipping Screws
Removable Back Panel
Hood
Transition
Model MLFS
5
Figure 1.
Figure 2.
1. e liner is shipped with the removable back-panel and the transition attached.
2. e transition is shipped upside-down in the liner and must be removed then, re-installed. (see Figure 1.)
3. If an in-hood fan is furnished, the transition is shipped separately. (see Figure 1. and 2.)
4. To detach the removable back-panel and the transition from the liner, remove the four (4) screws on the top and
four (4) screws on the back of the liner. (see Figure 1.)
5. Detach the transition from the removable back-panel by removing four (4) screws. e shipping screws will be
needed for re-installing the transition to the removable back-panel.
6. Secure the transition to the top of the removable back panel using the four (4) screws provided. Use duct tape
to seal the joints of the transition and the top of the removable back panel. (see Figure 2.)
7. Re-install the removable back-panel to the liner itself, then install the liner to the hood shell.