Use and Care Manual
- 1 -
PRO+AQUA ltration systems are designed in California
USA and are made from quality NSF Approved lters and
components.
System Inspection Before Starting
Remove the system and all the components out of the box, take note of all parts. Inspect the system
housings, ttings and connections carefully, make sure nothing was damaged during transit. If any part is
cracked or damaged, please do not proceed with the installation and contact us or your distributor for an
exchange or diagnosis.
Tools Recommended For Installation
• Variable Speed Drill
• Drill Bit
• Bolt Bit
• Adjustable Wrench
• Teon Tape
• Pen or Pencil
System Maintenance
All of our systems require little maintenance. The only regular maintenance required is lter replacement
every 4 - 6 or 6 - 12 months (depending on usage and water quality in your area). It is important to change
out your lters at the recommended intervals as indicated in this sheet to keep your system working
properly. When replacing any of the lter elements, pay special attention to the housing it belongs to as
installing the lters incorrectly will impact the performance of the system.
Components List
• 2 Stainless Steel Mounting Screws or Lag Bolts & Washer.
• 1 Bracket (Preinstalled).
• 3 housing (1 clear, 2 black)
• 3 Heads (Preinstalled on bracket)
• 1 Housing Wrench.