Use and Care Manual

1. Remove pre-filter if installed. Fill the WS-P-REG-KITV2 housing
with Standard Table Salt (see Salt Chart for correct amount) and
close clockwise. Insure to clean salt from o-ring for a secure seal.
Do not overfill salt pass the O-ring.
2. Connect the incoming water line to the “IN” port on the WS-P-
REG-KITV2 housing.
3. Connect one end of the Brine Hose to the “OUT” port of the WS-
P-REG-KITV2 housing using the QC Fitting.
4. Connect the other end of the brine hose to the “OUT” port of the
softener unit using the QC Fitting. Connection should be on the
“OUT” to “OUT” ports.
IN OUT
CLOSE
CLOCKWISE
TABLE
SALT
WATER SUPPLY
REGENERATION KIT
PART#: WS-P-REG-KITV2
IN OUT
IN
PORT
BRINE
WATER
OUT
PORT
BRINE
HOSE
OUT IN
BRINE WATER
WATER
SUPPLY
5. Stand WS-P-REG-KITV2 unit on floor.
6. Turn water on slowly until only a pencil size stream is slowly
flowing from the unit for 20-30 minutes. This water contains high
amounts of salt, do not drain on grass, flowers or trees.
7. After 20-30 minutes, turn water on all the way for an additional 10
minutes.
8. For systems larger than 16,000 grains, run additional loads as
needed following the above instructions and the Salt Chart
below.
9. Turn water o and disconnect the incoming water line from the
WS-P-REG-KITV2 unit and connect it directly to the “OUT” port
of the softener unit (Female adapter needed, not included) then,
turn the flow all the way on for 1-2 minute.
10. Once the unit has no salt water coming out, your unit is ready
for use!
11. Rinse the WS-P-REG-KITV2 unit to remove remaining salt and
place the pre-filter (FC-9-PF) back in housing. The WS-P-REG-
KITV2 can now be used as a pre-filter.
WS-P-REG-KITV2 Regenerating Instructions
1
2
3
Pro Tip: For best results let the water sit in the housing
overnight to allow the salt to dissolve and turn to brine.
WWW.PROAQUAWATER.COM
Professional Water Filtration Systems
8,000 Grains Half 26 oz. Box
16,000 Grains One 26 oz. Box
24,000 Grains Two 26 oz. Box
32,000 Grains Three 26 oz. Box
SALT CHART
Get all your product questions answered by our
Pro+Aqua certified support specialists.
Visit www.proaquawater.com for more information.
CERTIFIED
SUPPORT
B
E
S
T
I
N
C
L
A
S
S
S
U
P
P
O
R
T
N
O
-
H
A
S
S
L
E
W
A
R
R
A
N
T
Y
WS-P-REG-KIT_V4

Summary of content (2 pages)