Specifications
signal
distribution
14
BSS Signal Distribution
BSS BLU-320
No DSP•
Up to 16 mic/line inputs or line •
level outputs, configurable in
4 banks of 4 input or output
channels
BluLink 256 channel redundant •
audio bus
Audio CobraNet™ CM-1 module •
offering up to 32 x 32 network
channels
Analogue and digital input cards•
Integral multi-voltage switched •
mode PSU for lightweight and
universal AC mains operation
12 analogue control ports and 6 •
logic outputs for GPI hardware
interfacing using faders, pots,
switches etc
RS-232 port for third party serial •
control
Ethernet port for control network•
Networkable
Signal distribution is all about being able to route multiple source inputs to multiple zone outputs and provide remote control, from the
very simple to the very complex. There are a number of ways this can be done, with small non-programmable mixers, fixed signal chain
programmable distribution such a dbx ZonePro or SC Series. Alternatively you can use an open architecture platform like BSS Soundweb
(Green) or London (Blu), via the London Architect software you can create custom signal configurations using mixers, compressors, limiters,
crossovers, EQ and even room combining thus providing a tailored solution to exacting requirements. It is all relative to your customers
needs, but rest assured we have a solution for all occasions. To find out just what you need for your next distributed multizone installation
contact our Technical Resource Group on 02 9582 0909.
BSS BLU-800
Up to 16 mic/line inputs or line •
level outputs, configurable in
4 banks of 4 input or output
channels
BluLink 256 channel redundant •
audio bus
Room combining•
CobraNet•
TM
CM-1 module offering
up to 32 x 32 network channels
4 times DSP power of BLU 80•
Analogue and digital input cards•
Integral multi-voltage switched •
mode PSU for lightweight and
universal AC mains operation
12 analogue control ports and 6 •
logic outputs for GPI hardware
interfacing
RS-232 port for third party serial •
control
Ethernet port for control network•
BSS BLU-32
BSS BLU-120
No DSP•
Up to 16 mic/line inputs or line •
level outputs, configurable in
4 banks of 4 input or output
channels
BluLink 256 channel redundant •
audio bus
Analogue and digital input cards•
Integral multi-voltage switched •
mode PSU for lightweight and
universal AC mains operation
12 analogue control ports and 6 •
logic outputs for GPI hardware
interfacing using faders, pots,
switches etc
RS-232 port for third party serial •
control
Ethernet port for control network•
BSS BLU-160
Up to 16 mic/line inputs or line •
level outputs, configurable in
4 banks of 4 input or output
channels
BluLink 256 channel redundant •
audio bus
Room combining•
4 times DSP power of BLU 80•
Analogue and digital input cards•
Integral multi-voltage switched •
mode PSU for lightweight and
universal AC mains operation
12 analogue control ports and 6 •
logic outputs for GPI hardware
interfacing using faders, pots,
switches etc
RS-232 port for third party serial •
control
Ethernet port for control network•
BSS BLU-80
Up to 16 mic/line inputs or line •
level outputs in a single frame,
configurable in 4 banks of 4 input
or output channels
Peak Audio CobraNet™ CM-1 •
module offering up to 32 x 32
network channels
Massive DSP power in each frame•
Analogue and digital input cards•
Integral multi-voltage switched •
mode PSU for lightweight and
universal AC mains operation
12 analogue control ports and 6 •
logic outputs for GPI hardware
interfacing using faders, pots,
switches etc
Rear RS-232 port for third party •
serial control
Ethernet port for control network•
BSS BLU-10
The original Soundweb 9010 programmable controller
set new standards in control interfacing to DSP systems.
The Soundweb London equivalent, the BLU-10, builds
on that power and reputation by adding touch-screen
control to make a more attractive and potentially cost-saving control solution.
It is possible that a BLU-10 could replace a more expensive proprietary touch
screen solution where simpler control interfacing is required. Available in
black, white or blue.
BSS BLU-8
The BLU-8 is a programmable zone controller capable
of controlling a single zone, four zones or eight zones in
different modes of operation. A simple control surface
and informative visual feedback ensure that non-technical users can be
confident in making changes to an integrated AV system. The BLU-8 is
available in black or white.
BSS BLU-6
wall-mount controller
BLU-6 wall panels are simple controllers which allow the
designer to provide level control and source selection or
preset recall in a simple wall-mounted panel. 8 source
selections plus volume up and down buttons.
No DSP•
Up to 16 mic/line inputs or line •
level outputs, configurable in
4 banks of 4 input or output
channels
Analogue and digital input cards•
CobraNet™ CM-1 module offering •
up to 32 x 32 network channels
Integral multi-voltage switched •
mode PSU for lightweight and
universal AC mains operation
12 analogue control ports and 6 •
logic outputs for GPI hardware
interfacing using faders, pots,
switches etc
RS-232 port for third party serial •
control
Ethernet port for control network•