Apache 24 EP Rally Sport Owners Manual Electric Catamaran Boat Specifications Hull Length..........................................................................................24 in (609mm) Beam....................................................................................................8.5 in (216mm) Motor....................................................... Water-cooled hi-performance 550-size Radio System.......................................................
Introduction The Apache 24 comes Ready-To-Run with the Pro Boat 27MHz AM radio system and electronic speed controller already installed. All assembly and building is done at the factory, allowing you to quickly get your boat running. Thank you for purchasing the Pro Boat™ Apache 24 Ready-To-Run boat. Please read these instructions carefully before attempting to operate your boat. Table of Contents Introduction.................................................................................................
General Guidelines It is important that you read and follow this instruction manual, along with the radio system manual before you run this exciting boat. Failure to read and understand the manual could result is personal injury, property damage or permanent damage to your boat. It is also important to run your boat responsibly. With proper care and maintenance, you will be able to proudly enjoy your Apache 24 for many years to come. Before you operate your model, make sure that your frequency is clear.
Section 1: Installation of the Transmitter Batteries Install 8 “AA” alkaline batteries into the transmitter, following the instructions provided for your radio system. Turn on the transmitter, making sure that all three LEDs illuminate on the power indicator and that the trim knobs are in the center position. Turn the transmitter off. Section 2: Installation of the 7.2V Ni-Cd Battery Pack Make sure the receiver switch is in the "OFF" position. Install a fully charged 7.
Section 3: Checking the Radio System Ensure the antenna tube is properly placed through the hull. It may be necessary to slightly pull the antenna tube out to make certain the radio range is sufficient. Left Turn With the propeller free from any objects, give some throttle input to ensure that the motor is working.
Section 4: Adjusting the Transmitter Note: Refer to the radio instructions for specific information on transmitter setup. Adjust the rudder trim knob so that the rudder is centered prior to operation. You may adjust this control to make the boat run straight during operation. It may be necessary to adjust the throttle trim knob to stop the propeller from turning while the throttle trigger is in the neutral position.
Section 6: Handling Adjustment Operate your Apache 24 in low to medium wake conditions to avoid having problems with the boat overturning. If the conditions are questionable, adjust the prop strut down a bit to reduce the likelihood of having the boat overturn. You may also turn the dual rate dial down to reduce rudder travel in rough water conditions. Loosen to Adjust Outdrive Steering Dual Rate Section 7: Speed Control Programming 4.
Section 9: Lubricating the Drive Shaft 1. Loosen the 1.5mm setscrew connecting the drive shaft to the motor coupler. 4. Move the rudder assembly and slide the drive shaft out of the stuffing box. 2. Loosen the 1.5mm setscrew connecting the universal joint to the drive shaft. 5. Lubricate the drive shaft with drive shaft with PRB0100 Marine Grease. Reinstall the drive shaft in reverse order. Be sure to reinstall the nylon washer between the universal and the stuffing box. 3.
Section 10: Replacement Parts If you have any questions concerning the setup or running of your Apache 24 EP RS, please call the Horizon Service Center toll-free at (877) 504-0233.
Warranty Information Warranty Period IN CONTRACT, WARRANTY, NEGLIGENCE, OR STRICT LIABILITY. Further, in no event shall the liability of Horizon exceed the individual price of the Product on which liability is asserted. As Horizon has no control over use, setup, final assembly, modification or misuse, no liability shall be assumed nor accepted for any resulting damage or injury. By the act of use, setup or assembly, the user accepts all resulting liability. Horizon Hobby, Inc.
not responsible for merchandise until it arrives and is accepted at our facility. A Service Repair Request is available at www.horizonhobby.com on the “Support” tab. If you do not have internet access, please include a letter with your complete name, street address, email address and phone number where you can be reached during business days, your RMA number, a list of the included items, method of payment for any nonwarranty expenses and a brief summary of the problem.
© 2007, Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, Illinois 61822 (877) 504-0233 www.horizonhobby.