User Manual

• Assembled Blackjack 55 RTR

• JR

XR3i radio transmitter

• Boat stand

• Rudder (2)

Although the Blackjack

™

55 comes fully assembled and ready for action, you will need a few additional items

in order to run your boat. You will need the following:

Zenoah

2-Cycle Oil (ZEN20001) CA or Epoxy Glue

Flex Shaft Lubrication (PRB0100) Fuel Container

Fuel Pump (HAN155) Gasoline (+87 Octane), Ethanol-ree

12 AA Alkaline Batteries (8 for the transmitter and 4 for the receiver)

In addition to the items needed to run the Blackjack 55, we recommend that you carry the following in your

field box:

Engine Tuning Screwdriver (DYN2775) Clean Towels

Bronze Alloy Propeller (PRB0153) 2mm Hex Wrench

2.5mm Hex Wrench 4mm Hex Wrench

#1 Phillips Screwdriver Small Crescent Wrench

Wax Screw-locking Compound

m 1. There are 4 plywood boat stand pieces. The

2 short plywood pieces are the ends of the boat

stand.

m 2. Secure the 2 long plywood pieces of the

interlocking boat stand to one end of the short

plywood pieces. Repeat with the remaining short

plywood pieces.

m 3. Secure the stand together where each piece is

joined with epoxy or CA glue (not included).

m Unscrew the 2 knurled hatch-mounting screws

from the rear of the hatch. Slide the front hatch

retainer toward the rear of the boat and lift the

hatch from the boat.

Contents

Additional Required Items

Suggested Field Equipment and Supplies

Section 1: Building the Boat Stand

Section 2: Removing the Canopy