User Manual

16
17
The Pro Boat
™
Blackjack 55 should provide many
hours of exciting high-speed racing fun with just
minor maintenance. Preventative maintenance is
very important. Taking the time to ensure that
all the set screws and bolts are tight before each
operation of the boat will prevent many problems.
Before operating Blackjack 55:
Check that all screws and hardware are securely in
place. This is very important, as the manifold screws
will occasionally vibrate loose during the initial runs.
Check the propeller for damage in the form
of chipping or cracking. If you find any damage,
replace the propeller, as the damage will affect
the performance of the boat and could also
cause safety concerns.
When refueling, always wipe away any excess fuel
that may have spilled into or on the boat.
After operating the Blackjack 55:
Wipe off any exhaust residue from the boat. If
you operate the Blackjack 55 in salt water, it is
suggested that you thoroughly rinse the deck, hull,
and all the metal hardware with fresh water, then
dry them with a clean towel. After cleaning, coat all
metal parts with a silicone spray lubricant. This will
help to prevent corrosion.
Ensure that the radio box and equipment inside
is dry.
m 1. Loosen the two 1.5mm setscrews on the
brass ferrule located in front of the propeller
strut and remove the propeller shaft assembly
from the rear. Note that there is a nylon bushing
located on either end of the propeller strut.
m 2. Remove the lower propeller strut mounting
bolt and loosen the top bolt. Rotate the
propeller strut upwards to access the flex shaft.
m 3. Slide the flex shaft out of the boat.
m 4. Lubricate the flex shaft with flex shaft grease
(see your local hobby shop). Reinstall in reverse
order. Be sure to reinstall the nylon washers in
front and behind the propeller strut.
In the event that you need to purchase replacement parts for your engine or the Blackjack 55,
please see your local hobby store. You can also purchase them from Horizon Hobby by calling
1-800-338-4639 or shop online @ www.horizonhobby.com
Stock # Description
PRB2851 Hull Only
PRB2852 Canopy
PRB2655 Servo Tray
PRB2853 Boat Stand
PRB2657 Radio Box Cover
PRB2658 Fuel Tank
PRB2659 Kill Switch
PRB2660 Motor Mounting Plates
PRB2661 Manifold Cooling Plate
PRB2662 Manifold
PRB2663 Throttle Cable
PRB2664 Radio Box
PRB2665 Vibration Dampener
PRB2666 Tuned Pipe
PRB2855 Canopy Mounting Nut
PRB2669 Pushrod Bellow
PRB2670 Rudder Pushrods
PRB2671 Rx Switch Mount
PRB2672 Flex Shaft
PRB2673 Teflon Liner
PRB2281 Drive Dog
PRB2856 Rudder Strut with Bracket
PRB2857 Rudder Control Arm
PRB2677 Rudder
PRB2679 Cooling Tubing
PRB2680 Ball Linkage Set
PRB2854 Exhaust Port
PRB2683 Clutch
PRB2651 Water Pump with Bracket
PRB2684 Clutch Shoes
PRB2687 Clutch Springs
PRB2688 Clutch Bearing
PRB2858 Prop Strut with Bracket
PRB2690 Prop Shaft Nylon Bushing
PRB2691 Exhaust Spring
PRB2692 Throttle Cable Mount
PRB2693 Fuel Tank Straps
PRB2694 Stuffing Box
PRB2291 Propeller Nut
PRB0153 Bronze Alloy Propeller
PRB2282 Prop Shaft
PRB2068 Water Outlet
PRB2239 Drain Plug
PRB2695 Exhaust O-Ring Set
PRB0100 Grease Gun w/ Marine Grease
PRB0101 Marine Grease 5 oz.
PRB2861 Decal
PRB2859 Hull Handle
Pro Boat recommends PRB0100 Grease Gun with Marine Grease.
Section 17: Maintenance
Section 19: Flex Shaft Lubrication
Section 18: Blackjack 55 Replacement Parts