User guide

ManualsBrandsPro Boat ManualsHardwareDX3E

6 SPEKTRUM DX3E USER GUIDE

BATTERY LED MONITOR

A green LED battery monitor is located on the front left

of the transmitter next to the on/off switch. When the

battery voltage is above 5 volts the LED will be solid

green indicating that the battery has sufficient operational

voltage. Below 5 volts the green LED will begin to dim,

indicating the battery is low. When the voltage drops

below 4 volts, the green LED will turn off and only the

red LED will be lit, indicating the batteries should be

replaced immediately.

Solid Green - Battery is good

Dim Green - Battery voltage is low

No Green, only Solid Red - Battery voltage is critically

low. Replace batteries

OPTIONAL RUBBER GRIPS

The DX3E is supplied with a medium-size grip installed

on the transmitter. Optional small and large grips are

available (SPM9006) to fit preferences and hand sizes.

Each grip’s size is identified with an “S” (small), “M”

(medium), or “L” (large) on the inside of the grip for

easy identification. To remove, simply lift the edge of the

grip and continue around the grip until it is completely

removed. To replace, align the tabs of the grip to the slots

in the handle and press the grip in place.

RECEIVER COMPATIBILITY

The DX3E features DSM technology and is compatible

with Spektrum DSM and DSM2 surface receivers and the

marine receiver.

COMPATIBLE SPEKTRUM RECEIVERS

The DX3E is compatible with the following receivers.

Note: The DX3E operates in 16.5ms frame rate.

DSM

SR300 - 3-channel Sport - SPMSR300

SR3001 - 3-channel Pro - SPM1205

SR3300T - 3-channel with built-in telemetry - SPMSR3300T

SR3500 - 3-channel Micro Race - SPM1210

Note: The SR3000HRS (SPM1202) receiver

is designed to be used with Spektrum’s Futaba

HRS compatible module system only and is

not compatible with the DX3E.

DSM2

SR3100 - 3-channel Pro - SPMSR3100

SR3520 - 3-channel Micro Pro - SPMSR3520

Marine

MR3000 - 3-channel Marine - SPMMR3000

Please note that DSM2 and marine compatible

transmitters can be identified by the following logo

located on the back of the transmitter: