User guide

7SPEKTRUM DX3E USER GUIDE
RECEIVER CONNECTION AND
INSTALLATION
Typical Electric Installation
7.2V Battery
To Motor
Electronic
Speed Control
Receiver
Servo
SR300
DSM™:: 2.4Ghz
Typical Gas Installation
Receiver
Steering Servo
Throttle Servo
SR300
AUX
THR
Rx
STR
BAT/TEL
DSM™:: 2.4Ghz
SURFACE USE ONLY
©2009 Horizon Hobby, Inc.
6V Battery
BINDING A RECEIVER
1. With the receiver off insert the bind plug into the BND
port on the receiver.
2. Power the receiver through any other port. The amber
LED will flash continuously, indicating the receiver is
in bind mode.
3. With the steering wheel, throttle trigger and Aux
channel (if applicable) in the desired preset failsafe
positions, press and hold the bind button and turn
on the transmitter. The red LED on the front of
the transmitter will flash within a couple seconds
indicating the transmitter is in bind mode. Once the
red LED begins flashing, release the bind button.
Bind Plug LED
4. Within 15 seconds, the LED on the receiver will go
solid indicating a successful bind has taken place.
5. Remove the bind plug and store it in a convenient
place.
Note: You must rebind when:
•Differentfailsafepositionsaredesired,e.g.when
throttle or steering reversing has been changed.
•Changingreceivertypes,e.g.changingfromaDSM
receiver to a DSM2 or Marine receiver.
•Thereceiveristobeboundtoadifferenttransmitter.
Note: Some Spektrum receivers, like the SR3000, use a
bind button rather than a bind plug. The binding process
is the same with this receiver; however, instead of
inserting the plug before powering up the receiver, press
and hold the bind button while powering up the receiver
to enter bind mode.
Bind Plug
LED
EN