User guide

8 SPEKTRUM DX3E USER GUIDE
FAILSAFE
Failsafe positions are also set during binding. In the
unlikely event that the radio link is lost during use, the
receiver will drive the servos to their preprogrammed
failsafe positions (normally full brakes and straight
steering). If the SR300 receiver is turned on prior to
turning on the transmitter, the receiver will enter the
failsafe mode, driving the servos to their preset failsafe
positions. When the transmitter is turned on, normal
control is resumed. Failsafe servo positions are set
during binding (see Bind on the previous page).
SERVO REVERSING
Servo reversing is used to reverse the direction of the
output of each channel. (e.g., a right steering command
results in the wheels turning right). To reverse a channel,
switch the position of the correlating switch. “N” is for
normal. “R” is for reverse. A small screwdriver can be
used to move the switch if necessary.
Reverse Switch
Steering
Reverse Switch
Throttle
Reverse Switch
Auxiliary